
EK43 Standard Replacement (Coffee & Spices) Burr
EK Series Grinder Standard Replacement Burrs for coffee and spices. Compatible with both EK43 and EP43 grinder configurations.
EK Series Grinder Standard Replacement Burrs for coffee and spices. Compatible with both EK43 and EP43 grinder configurations.
This lives on the inside of your spout and is attached to the right rear spout screw. Upon installation, make sure that the strip is contacting the...
View full detailsK30 Seal ring 70x50x2 (Hopper Gasket), also works for EK43 and E65S grinders.
The EK43 mini-hopper is the perfect accessory for streamlining your EK43 or EK43S for espresso workflow. It includes a spring loaded closing device...
View full detailsReplacement shear plate for EK43 and EK43S grinder. Please note that this specific shear plate will only fit the aluminum prebreaker, which is blac...
View full detailsThis mechanical points type switch is what turns on the start capacitor, which gives the electrical boost to the motor when you first start the gri...
View full detailsThis slightly thinner hopper gasket made from a different, softer material than the K30 series can also be used on all K30 series grinders. This wo...
View full detailsAdjustment plate (faceplate) securing screw. 2 are required.
This spring is the same for all four springs for Kenia and 710 models. This spring is also for the front two springs for Guatemala vibrating spout.
Lives in the body of the grinder tower. Accessed from the bottom of the grinder. May be blue color or silver color and also works for the EK43 &...
View full detailsOur 2nd generation pre-breaker, made of aluminum and designed for 2nd generation EK43/EK43S grinders. These grinders can be identified with round, ...
View full detailsThis is a small parts set for the EK43 & EK43S knocker spout. This includes 4 spout screws, 4 springs and 4 bushings for a complete set.
Contactor for VTA 6S, EK43, and the Kenia/Guatemala series grinders. 208V/60cy, for single and three phaseContactor AF12-30-10-13 (ABB)
Supersedes mechanical type on/off switch #302365. Not interchangeable and you cannot upgrade from mechanical type unless you upgrade electronics. C...
View full detailsThis spring pushes the prebreaker back when you adjust to a courser position. These don't normally fail. Either it is missing from a reassembly or ...
View full detailsCopyright 2021 of Mahlkonig USA. Powered by Shopify