These 65mm burrs fit Kenia, Guatemala Lab model grinders. Note different inside diameter sizes. Larger inside diameter hole 308157 fits in the fixe...
View full details
Transparent Hopper for the Mahlkonig Guatemala and Kenia grinders. Please note that the clear and transparent hopper lid is sold separately, part 3...
View full details
Circuit breaker, 12.0 Amps, 115V 1~ also for EK43S, all Gua & Kenia, VTA single phase)
Standard spout for the Mahlkonig Guatemala and Kenia series grinders. NOTE: This is only the spout.
Bag Holder Shaft, Service Pack - for Kenia and Guatemala Grinders
15amp circuit breaker for GUA710, KeGu and GUA Lab grinders.
KeGu Stainless Cupping Bracket on Front of Grinder, used for resting the cupping recepticle
Grind adjustment cap service pack for the Mahlkonig Guatemala and Kenia series grinders.
This part fits all four positions for Kenia/710 and is also for Guatemala front two positions and right rear position.
Rotor with shaft for the Mahlkonig Guatemala and Kenia series grinders. (K22S) Ø70 x 65
Green "ON" microswitch for the Mahlkonig Guatemala and Kenia series grinders.
Power cord (3-wire, 14 AWG, 300VAC) with NEMA 5-15 plug for the Mahlkonig EK43 and Guatemala series grinders.
Threaded steel knocker ball for the Mahlkonig Guatemala Lab grinder. Also fits the VTA 6 S HMVC grinder.
Grinder casing cap for plastic spindle with 'coarse-fine' label for the Mahlkonig Guatemala and Kenia series grinders. (Old # 309937)
