
EK43 Contact strip (static strip)
This lives on the inside of your spout and is attached to the right rear spout screw. Upon installation, make sure that the strip is contacting the...
View full detailsThis lives on the inside of your spout and is attached to the right rear spout screw. Upon installation, make sure that the strip is contacting the...
View full detailsK30 Seal ring 70x50x2 (Hopper Gasket), also works for EK43 and E65S grinders.
Replacement shear plate for EK43 and EK43S grinder. Please note that this specific shear plate will only fit the aluminum prebreaker, which is blac...
View full detailsThis mechanical points type switch is what turns on the start capacitor, which gives the electrical boost to the motor when you first start the gri...
View full detailsThis slightly thinner hopper gasket made from a different, softer material than the K30 series can also be used on all K30 series grinders. This wo...
View full detailsAdjustment plate (faceplate) securing screw. 2 are required.
This spring is the same for all four springs for Kenia and 710 models. This spring is also for the front two springs for Guatemala vibrating spout.
Supersedes mechanical type on/off switch #302365. Not interchangeable and you cannot upgrade from mechanical type unless you upgrade electronics. C...
View full detailsThis spring pushes the prebreaker back when you adjust to a courser position. These don't normally fail. Either it is missing from a reassembly or ...
View full detailsEK43 Quick lock for bag holder shaft. Old part number was 301190.
Copyright 2021 of Mahlkonig USA. Powered by Shopify